3D-Printed Sculptures

These 3D-printed zoetrope sculptures were designed by John Edmark, and they only animate when filmed under a strobe light or with the help of a camera with an extremely short shutter speed. He shares about the project:

“These are 3-D printed sculptures designed to animate when spun under a strobe light. The placement of the appendages is determined by the same method nature uses in pinecones and sunflowers. The rotation speed is synchronized to the strobe so that one flash occurs every time the sculpture turns 137.5º—the golden angle. If you count the number of spirals on any of these sculptures you will find that they are always Fibonacci numbers.”

For this video, rather than using a strobe, the camera was set to a very short shutter speed (1/4000 sec) in order to freeze the spinning sculpture.

And the results are stunning!

Advertisements
This entry was posted in Uncategorized. Bookmark the permalink.

2 Responses to 3D-Printed Sculptures

  1. annj49 says:

    Interesting! 🙂

    Like

Comments are closed.